Series 9100
SUBMERSIBLE WASTEWATER Yeomans Pump
3905 Enterprise Ct. PH: 630-236-5500
Aurora, IL 60504 FX: 630-236-5511
GUIDE RAIL SYSTEM
SUGGESTED SPECIFICATIONS
PART I GENERAL
1.1 DESCRIPTION
Work Included: Under this section, the contractor shall provide all labor, equipment and material necessary to furnish, install,
test and place in operation Submersible Pumping Units as shown in the plans and as specified herein.
Other Project Specific Work
1.2 Related Work Described Elsewhere: Project Specific
1.3 GENERAL
Furnish and install________ Submersible Pumping Units complete with all accessories, controls and appurtenances as shown
in the plans and specified herein or as required for a complete operating system. Each Pumping Unit shall be rated for handling
unscreened sewage wastewater in accordance with the operating conditions defined in Table 1 of these specifications.
The design shall be such that the pumping units will be automatically connected to the discharge piping when lowered into place
on the discharge connection. The pump shall be easily removable for inspection or service without the need for removal of nuts,
bolts or other fasteners and without the need for personnel to enter the wet-well. Each pump shall be fitted with a (galvanized
steel chain, stainless steel cable, or stainless steel chain) of adequate strength and length to permit raising the pump for
inspection and removal.
1.4 QUALITY ASSURANCE
Qualifications of Manufacturers: The pumps shown and specified are based on the products manufactured by Yeomans Pump
Company, Aurora, Illinois. Catalog numbers and references are given only as an indication of the quality of materials and
workmanship to be used. Equal products by other manufacturers, approved by the Engineer and Owner, will be acceptable in
accordance with the Substitute Equipment requirements in the General Conditions Section of these Specifications.
1.5 QUALITY CONTROL
The Submersible Pumping Units shall conform to all applicable requirements of NEMA, IEEE. NEC, FM, SWPA and Hydraulic
Institute. For purposes of this specification, the revision and/or version of the referenced standards in effect on the date of bid
shall apply.
The Submersible Pumping Units specified shall be the products of reputable manufacturers who have been regularly engaged
in the design, manufacture and furnishing of Wastewater Pumping Equipment for at least ten (10) years. The manufacturer of
the pump shall assume full responsibility for the compatibility of the supplied components with the application. The motor and
pump shall be manufactured by one company providing sole source responsibility for the warranty of the unit. Manufacturers
who do not manufacture the submersible motor and who limit their warranty to that of the motor manufacturer shall not be
acceptable.